Berghof B-Nimis BC-PI powered by FLECS

Berghof Automation GmbH

Here you can learn how to install FLECS on a B-Nimis BC-Pi in just a few minutes.
Just read and follow the installation instructions in the description below.

Category:

Information

To make it as easy as possible for you to get started, we offer a single line command to install FLECS on the Berghof B-Nimis BC-Pi.

Our big promise: You will never have set up an automation system as fast as with FLECS.

The following instructions will help you to set up the B-Nimis BC-Pi within a few minutes and to take the first steps with FLECS. Enjoy the ride!

Prerequisites

Before you get started you will need a Berghof B-Nimis BC-Pi.

Step 1: Install FLECS

To proceed be sure to

- Connect the B-Nimis BC-Pi to your local network with a network cable.

- Connect the B-Nimis BC-Pi to the power supply and let it boot.

Enter the following command into the command line of your B-Nimis BC-Pi:
[vc_cta h2="Install FLECS for free by just running" style="flat" color="black"]

curl -fsSL install.flecs.tech | bash

[/vc_cta]
Step 2: Use FLECS

After the installation succeeded, you can access the FLECS UI by just entering the ip address, or hostname of your B-Nimis BC-Pi followed by the port 8080 in your browser.

Example: http://<ip-address>:8080

Reviews

There are no reviews yet.

Show only reviews in English (0)

Be the first to review “Berghof B-Nimis BC-PI powered by FLECS”

Your email address will not be published. Required fields are marked *

Vendor Information

  • Address:
  • No ratings found yet!

Product Enquiry

Please Login to make enquiry about this product
This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.